This free sewing pattern is a perfect stash-busting project. Depending on your size, you can make this top with less than 3/4 of a yard of fabric!
I’ve made this tutorial crystal-clear with step by step photos so that even a teenager can pull this together on their own.
To break her out of her “making pajama pants rut”, I taught her how to make this ultra simple tube top with a simple rectangle of fabric and elastic thread. If elastic thread intimidates you (it did me for a while!), don’t worry about it for another second. Sewing with elastic thread is just as easy as sewing with regular thread. I’d say it’s easier, because it does so much shaping of the fabric for you, so you don’t need to worry so much about cutting precisely.
Even though this project is easy enough for teens, don’t think you can’t whip up a few for yourself! You can finish them in less than 2 hours – more like an hour and a half, tops!
(ooooh… bad unintentional pun.)
Fabric (see measuring guide below)
Regular coordinating thread
1 spool of elastic thread
To determine how much fabric you need, print and complete this super-simple measuring guide:
*Disclaimer – If you have a rather busty figure, I’d recommend adding straps to this top!
To make this super-easy, press the fabric down 1/2 inch, then again another 1/2 inch. Then turn it over and topstich the hem in place with regular thread:
This may seem like a real pain in the rear, but it’s not. You can do it in less than 90 seconds. DON’T pull the elastic as you wind, simply keep it snug but unstretched. Then load the elastic thread bobbin into your sewing machine. Keep regular thread in your machine needle.
Line up the right side of your presser foot with the hem you just sewed. Now simply start sewing rows around your tube. You will be doing the exact same thing on both the top and bottom of the shirt, so you can start on either end. Make sure that you have the right side of the fabric on top, so that the elastic thread gets sewn on the wrong side of the fabric.
Some sewing machines may have a hard time if you backstitch the elastic thread at the beginning of your row. If so, just start and be sure to backstitch at the end of your rows.
These rows are also referred to as ‘smocking’.
Depending on the weight of your fabric, the elastic thread won’t pucker much at first. Don’t worry about this – a little steam iron magic will take care of it when we’re all done.
You are going to sew 5 rows of elastic thread on both the top and bottom of the shirt. Along with your hemmed row, that will be six stitched rows each.
Some people prefer to cut their thread and tie it off on each row. I prefer to keep it all one long piece of thread, to minimize any future breakage. To make sure that there is no pulling between the rows, pull the fabric away from your presser foot about 3 inches and then put it right back down under the presser foot, lined up along the previous seam. This will give it just enough slack to prevent puckering where you don’t want it to pucker.
One bobbin should be just about enough elastic thread to get through 5 rows. But if you run out, no worries. Just wind a new bobbin, start sewing where the old thread left off, and make sure you tie the ends together on the back of the fabric.
Continue sewing rows until you have 5 with the elastic thread.
When you are done with one end, it will look like this:
The back of the rows will look like this:
Do the same on the other end of the tube top.
When you’re all done, fire up your steam iron. Do not touch the thread with the iron! You simply need to hold the iron right above your elastic thread smocking and give it a few shots of steam. Your elastic will pucker right before your eyes.
You can also make this top with a completely different look by omitting the bottom smocking rows and wearing it with a belt. Adorable!